Thanks for the info I found it on the cd and I
did go online and get the xp version. It works great.. thanks..again for
the very fast reply on a Sunday!
I am amazed at what you can do with this
board. I have two now.. one I play with and the other my brother and I run
a rather large 10 ton 1980's NC copy mill. It is now a CNC by using the
FET-4 board. I like CNCpro buy my brother likes the EMC because of the
visual backplot while running programs. Both work good.
Here is what we use it on. The picture of the whole
mill was taken just before we installed the three axis control via
steppers. All of the adaptors and mounting brackets pictured were made by
this mill (we had to make temporary brackets in order to mill new ones
accurately).
Anyway I thought you might get a kick out of seeing
what we use the FET-4 for, thanks again.
